adiabatic Energy2D Forum › Forums › Energy2D Questions › adiabatic This topic contains 1 reply, has 2 voices, and was last updated by Charles Xie 3 months, 3 weeks ago. Viewing 2 posts - 1 through 2 (of 2 total) Author Posts March 23, 2019 at 6:50 am #200 arasukParticipant 1) How to create an adiabatic or insulated surface? 2) Is it possible to create a line? 3) Or in a rectangle, how to give different temperature on different lines of the same rectangle? Also may be one of the lines is adiabatic. March 23, 2019 at 1:49 pm #208 Charles XieKeymaster Since we use a grid to run the CFD simulation, you cannot use a line, which has no width and will be ignored by the engine. If you want to create layers of different temperatures, just create a few slabs and add them up. Author Posts Viewing 2 posts - 1 through 2 (of 2 total) You must be logged in to reply to this topic.